Gate Motor & Opener Cost in Lakewood - What It Actually Costs, Quoted Free

Typical price ranges for the work, then a free on-site estimate and a written quote for your driveway. Site prep, power runs and safety gear priced in, not added later.

✓ Licensed & Insured ✓ Written quotes ✓ Free estimates
Call (866) 330-9331

Call to schedule your free estimate

Work is performed by our local vetted partner.

🛡 Licensed & Insured 📝 Written Fixed-Price Quotes 💲 Upfront Pricing · Free Estimates
Wood & steel frameWood & steel frame
Wrought ironWrought iron
Farm & ranchFarm & ranch
Sliding driveway gatesSliding driveway gates
LiftMaster operatorsLiftMaster operators
Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate
Explore

Styles & brands we work with

  • Wrought iron
  • Wood & steel frame
  • Farm & ranch
  • Sliding driveway gates
  • LiftMaster operators
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

How Much Does Gate Motor & Opener Cost in Lakewood?

Gate motor and opener replacement in Lakewood typically costs $650 to $1,900 for a residential swing gate and $900 to $2,600 for a sliding gate, depending on the operator, the gate’s weight, and whether the existing wiring and control board can be reused. A single motor replacement on a working system usually lands at the low end; a full operator swap with new access control, safety sensors, and a control board sits at the high end. These are estimated ranges for the Lakewood market in 2026 – the written estimate after we look at your gate sets the final price.

We’re a gate-only trade. Every job we take is a gate job, which means we recognize a Mighty Mule board failure or a FAAC swing arm on sight, and we can give you a ballpark over the phone before anyone drives out. Call (866) 330-9331 for a free estimate.

What should you expect to pay for a gate opener in Lakewood?

Most Lakewood homeowners end up between $650 and $1,900 for a residential operator installed, or pay $250 to $650 for a repair that keeps the existing motor. Property managers with a commercial slide gate should plan on $1,200 to $2,600 for an operator replacement, since commercial-grade systems from DoorKing or FAAC carry more hardware, heavier arms, and more involved access control wiring. The numbers below break down what makes up that total so you can see where your money goes before you commit.

Gate Motor & Opener Cost Breakdown (2026)

Here’s how a typical gate operator job splits out in Lakewood. Ranges are estimates for the 2026 market; a written estimate confirms your number.

Line item Typical estimated cost
Diagnostic and on-site estimate Free
Control board replacement $250 – $550
Motor and gearbox repair (reuse existing operator) $250 – $650
Residential swing gate operator (single arm) $650 – $1,500 installed
Residential sliding gate operator $900 – $1,900 installed
Dual gate (two-leaf) operator setup $1,400 – $2,600 installed
Safety sensor / photo-eye pair $150 – $400
Access control: keypad, remote receiver, or entry panel $150 – $700
Low-voltage wiring run to a new operator location $200 – $900
Commercial-grade slide operator (DoorKing, FAAC, BFT) $1,200 – $2,600 installed
Manual gate converted to electric operation (full kit) $1,200 – $3,200

What pushes a Lakewood job up the range: gate weight and height, because a heavy ornamental steel leaf needs a stronger arm and more rigid mounting; a change of operator type, like moving from a swing gate to a slide gate; and existing wiring that’s undersized or routed through soil that has shifted. What pulls it down: a sound gate structure, working wiring, and a motor that only needs a control board or a gearbox rebuild instead of a full replacement. The gate frame itself does a lot of the deciding here. If a leaf is sagging or a slide gate is dragging, a new operator will strain against it, so we look at the whole gate from the motor to the hinge before we quote.

What Affects Gate Motor & Opener Pricing in Lakewood

  • Gate weight and material. A cedar or vinyl swing gate takes a lighter-duty arm than a welded steel leaf. Heavier leaves need stronger operators and more solid posts, and that shows up in the price.
  • Swing vs. slide. Sliding operators sit at the higher end because they involve a track, rollers, and a rack-and-pinion drive. If the driveway has a slope or the gate needs a cantilever to clear it, the hardware gets more specific and the cost climbs.
  • Brand and tier. A Mighty Mule or Ghost Controls residential operator is a different price tier from a FAAC or BFT commercial arm. We’re fluent in all of them across the nine brands we service – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule – so we can tell you what each option really costs over time, not just today.
  • Existing wiring and power. If the operator location already has low-voltage wiring and a live power source, you save the trenching and the run. If it doesn’t, that’s a real line item.
  • Access control and safety. Keypads, remotes, entry panels, and the safety photo-eyes that stop a gate on contact all add cost. Skipping safety sensors isn’t an option on a working electric gate.
  • Lakewood’s freeze and thaw cycles. Front Range winters move soil and frost heave can shift a gate post, throw a slide track out of level, and put extra strain on the operator. A gate that was fine in August can bind in January, and correcting that alignment is part of many spring repairs here.

How to save on gate motor & opener work in Lakewood

Start with a free on-site estimate. A gate that’s misdiagnosed costs more than one that’s looked at properly, and we’d rather tell you a $300 board repair will do the job than sell you a $1,500 operator you don’t need.

  • Repair before you replace. If the motor and gearbox are sound and only the control board or a sensor has failed, a repair usually runs $250 to $650 instead of a full swap. Ask the technician to test the motor under load before quoting a replacement.
  • Fix the gate structure first. A sagging leaf or a dragging slide gate destroys a healthy operator faster than anything else. Aligning the gate and packing a loose hinge is far cheaper than replacing the motor it’s been fighting.
  • Match the operator to the gate. Overbuying a commercial arm for a light residential gate, or undersizing an operator for a heavy steel leaf, both cost you. The right match lasts longer than the wrong one.
  • Keep the safety sensors. Removing photo-eyes to save $150 to $400 is a false economy on a gate that moves on its own. Safety sensors stop a closing gate on contact; keep them working.
  • Plan wiring once. If you’re converting a manual gate to electric, route the low-voltage wiring and the power feed in one visit rather than trenching twice.

We work on your brand, whether that’s a residential Ghost Controls or a commercial DoorKing, and the estimate is free. Call (866) 330-9331 to get a number.

Can you repair a gate operator instead of replacing it?

Often, yes – and a repair runs $250 to $650 versus $650 to $2,600 for a replacement. Control boards, gearboxes, limit switches, safety sensors, and remote receivers are all serviceable on most operators, including the nine brands we work on. Replacement makes more sense when the motor has seized, the housing has taken water, or the operator is a residential unit being asked to move a gate it was never built for. We test the system under load before we recommend a swap, because a seized motor and a failed board can look identical from the driveway.

Which gate opener brands do you service in Lakewood, and does brand change the price?

We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, and brand does affect the price. Residential operators like Mighty Mule, Ghost Controls, and Linear generally fall at the lower end of the ranges above, while commercial-grade FAAC, BFT, and DoorKing systems sit higher because of their heavier hardware and access control. The brand also changes how quick a repair is: a board we recognize and can source is a faster fix than one we have to chase down. It’s the difference between a gate specialist and a generalist guessing at what’s inside the housing.

Do you need to replace the whole operator when the motor fails?

No, not always – motor and gearbox repair runs $250 to $650 and usually keeps the existing operator. A failed motor doesn’t automatically mean a new operator, and a good technician checks the gearbox, the control board, and the gate’s own alignment first. If the motor has seized and the housing is sound, a rebuild can restore it. If the housing has rusted through or the unit is a residential operator on a gate it can’t handle, replacement is the honest call. We tell you which before you spend the money.

Is a manual-to-electric gate conversion worth it in Lakewood?

A full conversion kit to electric operation typically runs $1,200 to $3,200 installed. What makes it worth it: a heavy gate you’re tired of opening by hand every day, a property that needs controlled entry, and a gate structure already strong enough to carry an operator. What makes it more expensive: running new wiring, a gate that needs post reinforcement first, and access control. We look at the gate before we quote the kit, because a conversion on a gate that’s already sagging will cost more in the long run than fixing the gate first.

FAQs – Gate Motor & Opener Cost

How much does a gate motor cost in Lakewood?

A typical residential gate motor and opener replacement in Lakewood runs $650 to $1,900 installed, depending on whether it’s a swing or slide gate. Commercial-grade operators land between $1,200 and $2,600. Call (866) 330-9331 for an exact quote – estimates are free.

Is it cheaper to repair or replace a gate opener?

Repair is usually cheaper: $250 to $650 versus $650 to $2,600 for a full replacement. A control board, gearbox, or sensor fix keeps your existing operator and costs a fraction of a swap. If the motor has seized or the housing is compromised, replacement is the better value. Call (866) 330-9331 and we’ll test it under load before recommending either.

How much does an electric gate repair cost in Lakewood?

Most electric gate repairs in Lakewood run $250 to $650 for common failures like a control board, sensor, or gearbox problem. The range moves up if the fault is in the wiring or the access control system. Call (866) 330-9331 for a free on-site estimate – the written quote sets the final price.

Can you come out today?

We book same-day work whenever the schedule allows on Sunday through Friday, 7am to 7pm. We’re closed Saturday, and a call outside dispatch hours is booked into the next opening. Call (866) 330-9331. We answer 24/7.

How long does a gate opener replacement take?

A straight residential operator swap is usually a few hours, and a full conversion with new wiring can take most of a day. The on-site estimate tells you exactly what your gate needs, so you know the timeline before we start. Call (866) 330-9331 to schedule.

Why a gate-only specialist matters on a motor job

General handymen and broad garage-door companies dabble in gates. We don’t. Gate repair, electric gate repair, and gate installation are the three things we do, and our technicians have up to 12 years of experience on operators, control boards, sensors, and wiring. That focus shows up in the price you pay: we recognize the brand, we know the failure pattern, and we don’t spend your money learning on your gate. For a deeper look at what we handle, see Lakewood Gate Repair, and for local context on the area we serve, our Lakewood page covers the neighborhoods and gate types we see across the city.

Get a free gate motor estimate in Lakewood

The best way to know what your gate needs is to have it looked at. We offer free estimates and upfront pricing, we handle both residential and commercial systems, and we can work with your insurer where that’s relevant. Sediment and snowmelt from the Front Range keep gate posts and slide tracks moving, and an operator that’s aligned to a shifting gate lasts longer than one that isn’t. Call (866) 330-9331. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.

Pricing reflects the Lakewood market as of 2026. Lakewood Gate Repair offers free estimates – call (866) 330-9331.

Written by the team at Lakewood Gate Repair.

What Our Customers Say

★★★★★ 4.9 from 8+ reviews

"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."

- Dale Padgett

"Our slide gate had been dragging for months and getting worse. Turned out the chain was stretched and one of the guide rollers had seized. Both replaced, and he adjusted the limits so it stops properly at both ends now."

- Nicole Schaefer

"Gate stopped halfway and sat there for two days blocking the driveway. He found a dead capacitor in the operator, swapped it, and we were moving cars again in under an hour."

- Kristen Hayes
Need Gate Repair help in Lakewood? Licensed & insured · within the hour response · free estimates
Call (866) 330-9331

Request a Free Estimate

Tell us what's going on in Lakewood. We'll get back to you fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - We Answer 24/7
Local Service Coverage
Call Now - We Answer 24/7